Subwoofer Frequency Response Optimization by Means of Active Control (Electrical/Electronics Project)


Most subwoofer systems have difficulties producing frequencies in the low end of the hearing spectrum due to the added power requirements and instabilities. Active controls can transform the audio signal without changing physical characteristics and Continue reading

A Single-Stage Grid Connected Inverter Topology for Solar PV Systems With Maximum Power Point Tracking (Electronics – IEEE Project)

This paper proposes a high performance, single-stage inverter topology for grid connected PV systems. The proposed configuration can not only boost the usually low photovoltaic (PV) array voltage, but can also Continue reading

Microfabrication and Analysis of Manifold Microchannel Coolers for Power Electronics (Mechanical Project)

This research presents the analysis and realization of a single phase high performance manifold microchannel cooler for improving the thermal and hydrodynamic performance of multi-chip power electronic modules. This heat exchanger, microfabricated directly into the Continue reading

MATLAB/Simulink Implementation and Analysis of Three Pulse-Width-Modulation (PWM) Techniques (Electrical Project)


With advances in solid-state power electronic devices and microprocessors, various pulse-width-modulation (PWM) techniques have been developed for industrial applications. For example, PWM-based three-phase voltage source inverters (VSI) Continue reading

Virtual RC Damping of LCL-Filtered Voltage Source Converters With Extended Selective Harmonic Compensation (Electrical Project)


Active damping and harmonic compensation are two common challenges faced by LCL-filtered voltage source converters. To manage them holistically, this paper begins by proposing a virtual RC damper in Continue reading

Design Strategy for a 3-Phase Variable Frequency Drive (VFD) (Electrical Project)

This paper describes the design processes for a 3-Phase Variable Frequency Drive (VFD) as broken up into two stages: The AC-DC converter and the DC-AC converter. It acknowledges three (3) design versions, all. The output of the Continue reading

Tradeoff Analysis and Joint Optimization of Link-Layer Energy Efficiency and Effective Capacity Toward Green Communications (Electronics Project)

A joint optimization problem of link-layer energy efficiency (EE) and effective capacity (EC) in a Nakagami-m fading channel under a delay-outage probability constraint and Continue reading