The intent of this technical publication is to provide general guidance on the design of small solar-powered water pump systems for use with livestock operations or irrigation systems. This document provides a review of the basic elements of electricity, a description of the Continue reading
Get Latest Final Year Projects in your Email
Tag: Renewable Energy
Renewable for Rural Electrification in Sri Lanka (Mechanical Project)
At the beginning of the 1970s, the industrial countries accounted for about 80%of world oil consumption. Today, they are down to little more than 50%. Already, China uses more total primary energy than United States. Developing countries are in the process of Continue reading
Commercialization possibilities of Stirling engine technology for microscale power generation in Sweden (Mechanical Project)
The presented study has evaluated the possibility of commercializing a research project at the Royal Institute of Technologys (KTH) Department of Energy Technology (EGI) in Stockholm, Sweden, where a Stirling engine is used for renewable microscale power generation. The purpose of the study has been to Continue reading
Rural Electrification Using Renewable Energy Resources (Mechanical Project)
This study has been conducted as a Minor Field Study (MFS) and focuses on the electrification process of Rayal, a remote village in the Far Western Development Region of Nepal. The purpose of the study was to Continue reading
Wake Measurements Behind An Array Of Two Model Wind Turbines (Mechanical Projects)
During the last decades the exploitation of energy from the wind has become one of the most promising renewable energy technologies. The main strive in today’s Continue reading
Characterization and Utilization of Agroforestry Residues as Energy Source in Brazil (Mechanical Project)
Brazil is very much rich in agriculture and forestry. The agro industry occupies an area of 28840726 ha. The more important crops are sugarcane (7080920 ha), rice (289030 ha), Continue reading
Implementation of Solar Thermal Energy in a Small Residential Area: Case Study Kanalstaden (Mechanical Project)
This study investigates the feasibility of installing solar thermal energy systems on small residential districts and the practical issues that can arise. A residential district, planned to Continue reading
Cavitation Assessment of the Baihetan Discharge Tunnel – Using Computational Fluid Dynamics (Civil Project)
Recently it has become more common in the construction of large dams to reuse diversion tunnels as flood discharge tunnels in the final structure. These tunnels handle large flows with the characteristics of open channel flow. When such Continue reading
Design of a PV System With Variations of Hybrid System at Addis Ababa Institute of Technology (Mechanical/Electrical Project)
The aim of hybridizing renewable energy sources is that the main load shall be covered by the available solar energy source and other sources shall function as a complement when there is a deficiency in the main source. The aim of the system is to Continue reading
Evaluation Methods for Market Models Used in Smart Grids (Mechanical Project)
The European Union has set environmental targets on climate change in three areas: energy efficiency, renewable energy sources, and reduction of emissions. These targets are the main driver for Continue reading
Influence of Scaling Effects on Hub Loads of a Horizontal Wind Turbine (IEEE Electrical Project)
Wind industry aims to generate more energy and reduce energy cost by increasing energy capacity of machines. As a result the loading scales up non-linearly. Nowadays there is a lack of studies of Continue reading
Large Scale Monolithic Solar Panel Simulation – A Study on Partial Shading Degradation (Electrical Project)
Shadow-induced degradation is a major concern for both power output and long-term reliability in solar cells. Apart from the obvious fact that shading reduces the amount of solar irradiance available to solar panels, it may lead to formation of Continue reading